In our lives, we should all know the board-to-board connector, which is basically used in electronic devices, but do you know what the board-to-board connector needs to pay attention to in daily operation? Let’s take a look. I hope it helps.
After the device has been in use for a while, wait a few minutes. When the working components of the board-to-board connector have enough time to dissipate heat, otherwise if the load works for a long time, the metal terminals inside the connector will only lead to accelerated component aging, and due to the small size of the connector, if the compatibility temperature is not high enough, it will also cause some connector components to be damaged.
For the working environment of board-to-board connectors, it is also because there are many electroplated parts at the inner end of the connector. Use the connector in an environment that is too humid; otherwise, the humidity will affect the insulation function of the connector. Therefore, when selecting the connector, we must pay attention to the humidity of the working environment, whether it will affect the functional application of the connector.
Because the plastic base of the board to board connector is made in the injection molding segment, it is usually poured into the metal film after smoke cooling molding in the plastic department. The connector is widely used in electronic, electrical, instrument PCB circuit board. Its role is to connect the parts of the circuit that cannot be disconnected or connected. In this way, when the connector is used for a long time, some grease and other liquids will be deposited in it.
Importantly, oil from some components near the circuit may drip into the connector. Therefore, the application of the connector must not clean up the color or debris absorbed in the water in time, and do not deposit too much on the back to prevent the interface pin of the board-to-board connector from invading and simply causing some circuit defects.
Due to the large number of pins at the end of the interface, the board-to-board connector is used separately in the daily application of the connector. Please note that these connection holes must be kept clean, otherwise a certain amount of dust and debris will be deposited after the board to board connector is installed and will be continuously processed. In the future, it will not only affect the functional application of the connector, but also cause some details, resulting in some security risks.
Post time: Aug-15-2023